GSM
2G networks developed as a replacement for first generation (1G) analog cellular networks, and the GSM standard originally described a digital, circuit-switched network optimized for full duplex voice telephony. This expanded over time to include data communications, first by circuit-switched transport, then by packet data transport via GPRS (General Packet Radio Services) and EDGE (Enhanced Data rates for GSM Evolution or EGPRS).
Subsequently, the 3GPP developed third-generation (3G) UMTS standards followed by fourth-generation (4G) LTE Advanced standards, which do not form part of the ETSI GSM standard.
"GSM" is a trademark owned by the GSM Association. It may also refer to the (initially) most common voice codec used, Full Rate.
History
In 1982, work began to develop a European standard for digital cellular voice telephony when the European Conference of Postal and Telecommunications Administrations (CEPT) created the Groupe Spécial Mobile committee and later provided a permanent technical support group based in Paris. Five years later, in 1987, 15 representatives from 13 European countries signed a memorandum of understanding in Copenhagen to develop and deploy a common cellular telephone system across Europe, and EU rules were passed to make GSM a mandatory standard.[4] The decision to develop a continental standard eventually resulted in a unified, open, standard-based network which was larger than that in the United States.[5][6][7][8]In 1987 Europe produced the very first agreed GSM Technical Specification in February. Ministers from the four big EU countries cemented their political support for GSM with the Bonn Declaration on Global Information Networks in May and the GSM MoU was tabled for signature in September. The MoU drew-in mobile operators from across Europe to pledge to invest in new GSM networks to an ambitious common date. It got GSM up and running fast.
In this short 37-week period the whole of Europe (countries and industries) had been brought behind GSM in a rare unity and speed guided by four public officials Armin Silberhorn (Germany), Stephen Temple (UK), Philippe Dupuis (France), and Renzo Failli (Italy).[9] In 1989, the Groupe Spécial Mobile committee was transferred from CEPT to the European Telecommunications Standards Institute (ETSI).[6][7][7][8]
In parallel, France and Germany signed a joint development agreement in 1984 and were joined by Italy and the UK in 1986. In 1986 the European Commission proposed reserving the 900 MHz spectrum band for GSM. The world's first GSM call was made by the former Finnish prime minister Harri Holkeri to Kaarina Suonio (mayor in city of Tampere) on July 1, 1991, on a network built by Telenokia and Siemens and operated by Radiolinja.[10] The following year in 1992, the first short messaging service (SMS or "text message") message was sent and Vodafone UK and Telecom Finland signed the first international roaming agreement.
Work began in 1991 to expand the GSM standard to the 1800 MHz frequency band and the first 1800 MHz network became operational in the UK by 1993. Also that year, Telecom Australia became the first network operator to deploy a GSM network outside Europe and the first practical hand-held GSM mobile phone became available.
In 1995, fax, data and SMS messaging services were launched commercially, the first 1900 MHz GSM network became operational in the United States and GSM subscribers worldwide exceeded 10 million. Also this year, the GSM Association was formed. Pre-paid GSM SIM cards were launched in 1996 and worldwide GSM subscribers passed 100 million in 1998.[7]
In 2000, the first commercial GPRS services were launched and the first GPRS compatible handsets became available for sale. In 2001 the first UMTS (W-CDMA) network was launched, a 3G technology that is not part of GSM. Worldwide GSM subscribers exceeded 500 million. In 2002 the first Multimedia Messaging Service (MMS) were introduced and the first GSM network in the 800 MHz frequency band became operational. EDGE services first became operational in a network in 2003 and the number of worldwide GSM subscribers exceeded 1 billion in 2004.[7]
By 2005, GSM networks accounted for more than 75% of the worldwide cellular network market, serving 1.5 billion subscribers. In 2005 the first HSDPA capable network also became operational. The first HSUPA network was launched in 2007. High-Speed Packet Access (HSPA) and its uplink and downlink versions are 3G technologies, not part of GSM. Worldwide GSM subscribers exceeded three billion in 2008.[7]
The GSM Association estimated in 2010 that technologies defined in the GSM standard serve 80% of the global mobile market, encompassing more than 5 billion people across more than 212 countries and territories, making GSM the most ubiquitous of the many standards for cellular networks.[11]
It is important to note that GSM is a second-generation (2G) standard employing Time-Division Multiple-Access (TDMA) spectrum-sharing, issued by the European Telecommunications Standards Institute (ETSI). The GSM standard does not include the 3G UMTS CDMA-based technology nor the 4G LTE OFDMA-based technology standards issued by the 3GPP.[12]
Macau planned to phase out its 2G GSM networks as of June 4, 2015, making it the first region to decommission a GSM network.[13] Singapore will also be phasing out 2G services by April 2017.
Technical details
 |
| The structure of a GSM network |
Main article: GSM services
Network structure
The network is structured into a number of discrete sections:- Base Station Subsystem – the base stations and their controllers explained
- Network and Switching Subsystem – the part of the network most similar to a fixed network, sometimes just called the "core network"
- GPRS Core Network – the optional part which allows packet-based Internet connections
- Operations support system (OSS) – network maintenance
Base station subsystem
Main article: Base Station subsystem
 |
| GSM cell site antennas in the Deutsches Museum, Munich, Germany |
Cell horizontal radius varies depending on antenna height, antenna gain, and propagation conditions from a couple of hundred meters to several tens of kilometres. The longest distance the GSM specification supports in practical use is 35 kilometres (22 mi). There are also several implementations of the concept of an extended cell,[14] where the cell radius could be double or even more, depending on the antenna system, the type of terrain, and the timing advance.
Indoor coverage is also supported by GSM and may be achieved by using an indoor picocell base station, or an indoor repeater with distributed indoor antennas fed through power splitters, to deliver the radio signals from an antenna outdoors to the separate indoor distributed antenna system. These are typically deployed when significant call capacity is needed indoors, like in shopping centers or airports. However, this is not a prerequisite, since indoor coverage is also provided by in-building penetration of the radio signals from any nearby cell.
GSM carrier frequencies
Main article: GSM frequency bands
GSM networks operate in a number of different carrier frequency ranges (separated into GSM frequency ranges for 2G and UMTS frequency bands for 3G), with most 2G
GSM networks operating in the 900 MHz or 1800 MHz bands. Where these
bands were already allocated, the 850 MHz and 1900 MHz bands were used
instead (for example in Canada and the United States). In rare cases the
400 and 450 MHz frequency bands are assigned in some countries because
they were previously used for first-generation systems.Most 3G networks in Europe operate in the 2100 MHz frequency band. For more information on worldwide GSM frequency usage, see GSM frequency bands.
Regardless of the frequency selected by an operator, it is divided into timeslots for individual phones. This allows eight full-rate or sixteen half-rate speech channels per radio frequency. These eight radio timeslots (or burst periods) are grouped into a TDMA frame. Half-rate channels use alternate frames in the same timeslot. The channel data rate for all 8 channels is 270.833 kbit/s, and the frame duration is 4.615 ms.
The transmission power in the handset is limited to a maximum of 2 watts in GSM 850/900 and 1 watt in GSM 1800/1900.
Voice codecs
GSM has used a variety of voice codecs to squeeze 3.1 kHz audio into between 6.5 and 13 kbit/s. Originally, two codecs, named after the types of data channel they were allocated, were used, called Half Rate (6.5 kbit/s) and Full Rate (13 kbit/s). These used a system based on linear predictive coding (LPC). In addition to being efficient with bitrates, these codecs also made it easier to identify more important parts of the audio, allowing the air interface layer to prioritize and better protect these parts of the signal.As GSM was further enhanced in 1997[15] with the Enhanced Full Rate (EFR) codec, a 12.2 kbit/s codec that uses a full-rate channel. Finally, with the development of UMTS, EFR was refactored into a variable-rate codec called AMR-Narrowband, which is high quality and robust against interference when used on full-rate channels, or less robust but still relatively high quality when used in good radio conditions on half-rate channel.
Subscriber Identity Module (SIM)
Main article: Subscriber Identity Module
One of the key features of GSM is the Subscriber Identity Module, commonly known as a SIM card. The SIM is a detachable smart card
containing the user's subscription information and phone book. This
allows the user to retain his or her information after switching
handsets. Alternatively, the user can also change operators while
retaining the handset simply by changing the SIM. Some operators will
block this by allowing the phone to use only a single SIM, or only a SIM
issued by them; this practice is known as SIM locking.Phone locking
Main article: SIM lock
Sometimes mobile network operators restrict handsets that they sell for use with their own network. This is called locking
and is implemented by a software feature of the phone. A subscriber may
usually contact the provider to remove the lock for a fee, utilize
private services to remove the lock, or use software and websites to
unlock the handset themselves.In some countries (e.g., Bangladesh, Belgium, Brazil, Chile, Germany, Hong Kong, India, Iran, Lebanon, Malaysia, Nepal, Pakistan, Poland, Singapore, South Africa, Thailand) all phones are sold unlocked.[16]
GSM Security
GSM was intended to be a secure wireless system. It has considered the user authentication using a pre-shared key and challenge-response, and over-the-air encryption. However, GSM is vulnerable to different class of attacks, each of them aiming a different part of the network.[17]The development of UMTS introduces an optional Universal Subscriber Identity Module (USIM), that uses a longer authentication key to give greater security, as well as mutually authenticating the network and the user, whereas GSM only authenticates the user to the network (and not vice versa). The security model therefore offers confidentiality and authentication, but limited authorization capabilities, and no non-repudiation.
GSM uses several cryptographic algorithms for security. The A5/1, A5/2, and A5/3 stream ciphers are used for ensuring over-the-air voice privacy. A5/1 was developed first and is a stronger algorithm used within Europe and the United States; A5/2 is weaker and used in other countries. Serious weaknesses have been found in both algorithms: it is possible to break A5/2 in real-time with a ciphertext-only attack, and in January 2007, The Hacker's Choice started the A5/1 cracking project with plans to use FPGAs that allow A5/1 to be broken with a rainbow table attack.[18] The system supports multiple algorithms so operators may replace that cipher with a stronger one.
Since 2000, different efforts have been done in order to crack the A5 encryption algorithms. Both A5/1 and A5/2 algorithms are broken, and their cryptanalysis has been considered in the literature. As an example, Karsten Nohl developed a number of rainbow tables (static values which reduce the time needed to carry out an attack) and have found new sources for known plaintext attacks.[19] He said that it is possible to build "a full GSM interceptor...from open-source components" but that they had not done so because of legal concerns.[20] Nohl claimed that he was able to intercept voice and text conversations by impersonating another user to listen to voicemail, make calls, or send text messages using a seven-year-old Motorola cellphone and decryption software available for free online.[21]
New attacks have been observed that take advantage of poor security implementations, architecture, and development for smartphone applications. Some wiretapping and eavesdropping techniques hijack the audio input and output providing an opportunity for a third party to listen in to the conversation.[22]
GSM uses General Packet Radio Service (GPRS) for data transmissions like browsing the web. The most commonly deployed GPRS ciphers were publicly broken in 2011.[23]
The researchers revealed flaws in the commonly used GEA/1 and GEA/2 ciphers and published the open-source "gprsdecode" software for sniffing GPRS networks. They also noted that some carriers do not encrypt the data (i.e., using GEA/0) in order to detect the use of traffic or protocols they do not like (e.g., Skype), leaving customers unprotected. GEA/3 seems to remain relatively hard to break and is said to be in use on some more modern networks. If used with USIM to prevent connections to fake base stations and downgrade attacks, users will be protected in the medium term, though migration to 128-bit GEA/4 is still recommended.
source : Wikipedia
0 komentar:
Posting Komentar